ATF Level In Rear Final Drive 0BF And 0BE, Checking
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Test Requirement
- ATF temperature: 10 °C to 60 °C (50 °F to (140 °F)
- The rear final drive must be in the installed position.
- The vehicle must be level.
Special tools and workshop equipment required
- Drip Tray
-- Remove the ATF check plug -1- to check the ATF level.
CAUTION:
- The ATF check plug -1- is located on the left side of the rear final drive. Identification >>ATF<< on the final drive housing -arrow-
- ATF sealing plug overview. Refer to Figure.
- The ATF level is correct when the rear final drive is filled to the lower edge of the fill hole.
If the ATF is correct:
-- Install the new ATF check plug and fasten. Tightening specification, refer to -item 12- ATF Check Plug (See Figure).
If the ATF is not correct:
-- Fill with ATF. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .