Overview - Camshaft Timing Chains: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 4 Nm + 90°
- Always replace after removing.
- Chain Tensioner
- Is under tension
- Secure using :T40267 before removing
- Timing Chain Tensioning Rail
- Guide Pin
- 20 Nm
- Bolt
- Tightening sequence. Refer to Figure.
- Always replace after removing.
- Adapter Sleeve
- Depending on the version, not present on every bearing bracket
- Control Valves
- 35 Nm
- Left-hand thread
- Different versions depending on the version.
- Remove from the :T10352A using a tool
- Bearing Bracket
- Removing and installing. Refer to BEARING BRACKET, REMOVING AND INSTALLING .
- Camshaft Timing Chain Guide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the running direction with paint
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- After procedures on the chain drive perform the adaptation using the Vehicle Diagnostic Tester
- Camshaft Timing Chain Guide Rail
- Guide Pin
- 20 Nm
- Three Stage Chain Sprocket
- Crankshaft
- Installation position. Refer to .