Clamping Sleeves, Installing

Fig 1: Identifying Boot Clamp Installation Dimension

Courtesy of AUDI OF AMERICA, LLC

-- Install a new clamp and tension it using the :VAG1275A  .

-- Align tie rod so that tie rod ball joint pints are in installation location.

-- Insert the tie rod into the wheel bearing housing as far as the stop.

-- Install the wheel and tighten. Refer to WHEELS AND TIRES .

-- Lower the vehicle onto its wheels. Refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .

-- An axle alignment may be required. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .