Overview - Power Steering Pump, Vehicles Without Dynamic Steering With 6-Cylinder Engine

NOTE:

Always replace seals.

Do not reuse fluid you have drained.

Only use Hydraulic Fluid.

Fig 1: Exploded View Of Power Steering Pump, Vehicles Without Dynamic Steering With 6-Cylinder Engine

Courtesy of AUDI OF AMERICA, LLC

1. Bracket
2. Sleeve
   • Drive the sleeve back slightly to install the power steering pump.
3. Bolt
   • 25 Nm
4. Bolt
   • 9 Nm
5. Seal
   • Always replace if removed
6. Pressure Line
   CAUTION:

   • Insert the pressure line completely when installing.
7. Intake Hose
   • The "P" marking on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump.
8. Clamp
   • Tension using Hose Clip Pliers:VAG1275A 
   • Always replace if removed
9. Bolt
   • 22 Nm
10. Belt Pulley
11. Power Steering Pump
    • For allocation. Refer to the Parts information.
    • Fill with Hydraulic Fluid before installing
    • Delivery pressure, checking. Refer to POWER STEERING PUMP DELIVERY PRESSURE, CHECKING, VEHICLES WITH 6-CYLINDER ENGINE .
    • Removing and installing. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, VEHICLES WITHOUT DYNAMIC STEERING WITH 6-CYLINDER ENGINE .
    • Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
    • Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
    • Steering system, checking for leaks. Refer to STEERING, BLEEDING AFTER REPLACING .
12. Bolt
    • 25 Nm