Flange Shaft Ring, Replacing, 0BC

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

The ring can only be replaced with the final drive and the flange shaft removed.

Special Tools And Workshop Equipment Required

Thrust Plate VW 401
Thrust Plate VW 402
Thrust Disc VW 412
Press Support-R and R Ball Joints3146
Kukko Separating Tool 22-115 mm, for example, Kukko Separating Tool 22-115 mm 17/2

The rear final drive is removed. Refer to FINAL DRIVE .
Flange shaft removed. Refer to LEFT SEAL, REPLACING, 0BC .

Fig 1: Identifying Separating Tool

Courtesy of AUDI OF AMERICA, LLC

B - Separating tool 22 to 115 mm, for example Kukko Separating Tool 22-115 mm 17/2

Fig 2: Installing Ring -A- On Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

Ring installed position -A- : the larger outer diameter faces the flange.