All Wheel Drive Pump -V415-, 0BE, 0BF: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hydraulic Pump

Courtesy of AUDI OF AMERICA, LLC

The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump, refer to Figure.
The adapter -B- is installed in the recesses in the hydraulic pump.
A new O-ring -D- is on the All Wheel Drive Pump -V415-.

-- Install the All Wheel Drive Pump -V415- with the coupling -C- in the adapter -B-.

-- Diagonally tighten the 4 bolts on the All Wheel Drive Pump -V415- -2- to the tightening specification -item 1- in HYDRAULIC CONTROL UNIT, 0BE, 0BF .

Fig 2: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -1- to the All Wheel Drive Pump -V415-.

-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0BE, 0BF .