Additional Work After Replacing All Wheel Drive Control Module -J492-
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only perform the additional work only if the All Wheel Drive Control Module -J492- was replaced.
-- Connect the Vehicle Diagnostic Tester and turn on the ignition.
-- Select the function 22 - All Wheel Drive Electronics in the Vehicle Diagnostic Tester under Guided Functions in the directory 22- Replacing Control Module .
- Follow all the instructions given by the Vehicle Diagnostic Tester exactly.
With the Vehicle Diagnostic Tester the installed rear final drive "adapts" on the All Wheel Drive Control Module -J492-.
NOTE:
A system check will take place when the 22 - Control Module Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.