LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (Wheels, Tires & Wheel Alignment) >> 44 Wheels, Tires, Wheel Alignment >> Vehicle Alignment >> Evaluating Need For Axle Alignment

Evaluating Need For Axle Alignment

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

When Vehicle Alignment is Necessary

A component on the front axle was replaced: Wheel alignment check required A component on the rear axle was replaced: Wheel alignment check required
  Yes No   Yes No
Upper rear control arm   X Air spring damper   X
Upper front control arm   X Upper transverse link X  
Lower guide control arm   X Lower transverse link X  
Lower track control arm   X Bonded rubber bushing   X
Ball Joint   X      
Air spring damper   X Air spring damper   X
Shock absorber fork   X      
Wheel bearing housing   X Wheel bearing housing X  
Tie rod X   Tie rod X  
Tie rod end X        
Steering Gear X        
Subframe X   Subframe X  
Stabilizer bar   X Stabilizer bar   X
Coupling rod   X Coupling rod   X
  • 1) If the subframe was secured with the Subframe Locating Pins T40242, axle alignment is not necessary.
A component on the front axle was removed and reinstalled: Wheel alignment check required A component on the rear axle was removed and reinstalled: Wheel alignment check required
  Yes No   Yes No
Upper rear control arm   X Air spring damper   X
Upper front control arm   X Upper transverse link X  
Lower guide control arm   X Lower transverse link X  
Lower track control arm   X Bonded rubber bushing   X
Ball Joint   X      
Air spring damper   X Air spring damper   X
Shock absorber fork   X      
Wheel bearing housing   X Wheel bearing housing X  
Tie rod X   Tie rod X  
Steering Gear X        
Subframe X   Subframe   X1)
Stabilizer bar   X Stabilizer bar   X
Coupling rod   X Coupling rod   X
  • 1) If the subframe was secured with the Subframe Locating Pins T40242, axle alignment is not necessary.