LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (4.0L - Turbocharger & Supercharger - Engine Code(S): CEUA, CGTA, CTFA & CTGA) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler, Removing And Installing >> Installing

Charge Air Cooler, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

If there are small impressions on the fins, refer to COOLER AND CONDENSER ASSEMBLY .

Replace the seal.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

All of the coolant must be changed if the radiator was replaced.

-- Check the coolant level, refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals