Preliminary Work For Replacing Belt Pulley

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition.

-- Remove the front noise insulation. Refer to FRONT NOISE INSULATION .

-- Mark the running direction of the ribbed belt (always refer to the repair information for the routing of the ribbed belt for each engine) .

-- Release the tension on the ribbed belt and then remove it. Refer to RIBBED BELT, REMOVING AND INSTALLING for CALB, RIBBED BELT, REMOVING AND INSTALLING for CPNB, OVERVIEW - RIBBED BELT DRIVE for CTUC, CTUB and CTUD, or RIBBED BELT TENSIONING DAMPER, REMOVING AND INSTALLING, NON-HYBRID VEHICLES WITH ALL ENGINE CODES EXCEPT CDZA for CAEB, CPMA, CPMB and CHJA .

NOTE:

Mark direction of rotation of ribbed belt using chalk or felt-tip marker before removing. Running a used belt in the opposite direction could destroy it.