Control Position, Programming
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
WARNING:
- During a test drive, the testing and measuring equipment must always be secured on the back seat.
- These devices may be operated only by a passenger during a test drive.
-- Connect the Vehicle Diagnostic Tester
-- Switch on the Vehicle Diagnostic Tester.
The Vehicle Diagnostic Tester is ready for operation when the operating modes are displayed.
-- Turn on the ignition.
Requirements
- The vehicle must be standing on an even surface.
- The vehicle may not be loaded.
- The Electronic Damping Control Module -J250- must be coded.
- The DTC memory may not contain any vehicle level sensor -- DTC memory entries.
NOTE:
If control modules or electric/electronic components were replaced, then the components must be adapted under "Guided Functions ".
-- Touch Guided Functions and the screen.
Then:
-- Select the corresponding program in "Guided Functions ".
-- Follow the prompts on the screen.
NOTE:
If the control position was programmed again on vehicles with lane assist, the Directional Stabilization Assistance Control Module -J759- with integrated camera must be calibrated. Refer to LANE ASSIST, CALIBRATING .