Installing The Over-Center Spring

Fig 1: Clipping Bearing Shell

Courtesy of AUDI OF AMERICA, LLC

-- Clip the bearing shell -1- in the appropriate bearing position.

-- Install the over-center spring -2-.

• The black side -arrow C- faces the clutch pedal.

-- Press the clutch pedal -1- down as far as the stop and insert the over-center spring -2- with the T40025.

Fig 2: Actuating Clutch Pedal

Courtesy of AUDI OF AMERICA, LLC

-- Pull the clutch pedal back to its rest position. Remove the assembly clamp while the over-center spring is stretched.

-- Install the footwell vent. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN PASSENGER COMPARTMENT .

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Install the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .