Tunnel CROSSMEMBER: Removing

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear noise insulation by loosening the fasteners -2 and 3-

-- Position the V.A.G 1383 A plunger with the T10337 attached on the bottom of the transmission.

Fig 2: Supporting Transmission With V.A.G 1383

Courtesy of AUDI OF AMERICA, LLC

-- Lift the transmission slightly using the V.A.G 1383 A.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 3: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrow- and the tunnel crossmember.

Fig 4: Identifying Nuts And Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC