Transmission Neutral Position Sensor -G701-: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the fasteners -2 and 3- and remove the rear noise insulation.

-- Move gearshift lever -2- forward in direction of -arrow- and shift into 4th gear.

Fig 2: Identifying Gearshift Assembly

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -1-.

-- Disconnect the connector from the transmission neutral position sensor -G701- -1-.

Fig 3: Identifying Connector To Transmission Neutral Position Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and remove the transmission neutral position sensor -- -A-.

Fig 4: Identifying Bolt -Arrow- And Remove Transmission Neutral Position Sensor -A-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The cover -B- remains installed.