Noise Insulation: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Mounting Noise Insulation On Tabs -1- And Then Push Down On It Until Tabs -2- Lock

Courtesy of AUDI OF AMERICA, LLC

-- Mount the noise insulation on the tabs -1- and then push down on it until the tabs -2- lock.

-- Stretch the boot over the shift lever into the rounded groove -arrow A-.

-- Press the support ring into the boot over the shift lever support in the direction of -arrow B- as far as the stop.

Install in reverse order of removal. Note the following:

-- Install the multimedia system control head -E380-. Refer to MULTIMEDIA SYSTEM CONTROL HEAD -E380-, REMOVING AND INSTALLING .

-- Install the shift lever knob with the shift lever boot. Refer to SHIFT KNOB WITH SHIFT LEVER BOOT .