Gear Recognition Sensor: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear noise insulation by loosening the fasteners -2 and 3-.

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged.

-- Disconnect exhaust system at double clamp -arrow-.

Fig 2: Loosening Clamping Sleeve

Courtesy of AUDI OF AMERICA, LLC

-- Move the front exhaust pipe to the side and secure it on the rear section of the exhaust system (clamping sleeve) with wire.

-- Position the V.A.G 1383 A plunger with the T10337 attached on the bottom of the transmission.

Fig 3: Supporting Transmission With V.A.G 1383

Courtesy of AUDI OF AMERICA, LLC

-- Lift the transmission slightly using the V.A.G 1383 A.

WARNING:

There is the risk of an accident.

The V.A.G 1383 A may only be used during assembly and must not sit unsupervised under the vehicle.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 4: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Lower the transmission to dimension -a- using the V.A.G 1383 A.

Fig 5: Lowering Transmission

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

Fig 6: Installing Connector On Transmission Range Gear Recognition Switch

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Disregard -1 and 2-.

-- Remove the bolt -1- and remove the gear recognition sensor -G604- -3-.

Fig 7: Removing Bolt -1- And Remove Gear Recognition Sensor -G604- -3-

Courtesy of AUDI OF AMERICA, LLC