Securing The Engine To The Manual Transmission

WARNING: This page is about a different variant/trim than selected.

Fig 1: Mounting Transmission To Engine

Courtesy of AUDI OF AMERICA, LLC

Item

Bolt

1 ¹⁾

M10x50 ²⁾

2 ¹⁾ , 3 ••• 6

M12x100 ³⁾

30 + 90°

M12x125 ³⁾

30 + 90°

8, 11

M10x60 ³⁾

15 + 90°

9, 10

M10x95 ³⁾

15 + 90°

Alignment sleeve for centering

¹⁾ Mount the auxiliary adapter.
²⁾ Bolt strength rating 10.9. There is no limit to the number of times steel bolts may be used.
³⁾ See if it is possible to use the aluminum bolts again. Replace them if necessary.TRANSMISSION, INSTALLING .

⁽¹⁾	To prevent damaging the bolts when marking them, do not clamp them in a vise. Insert the bolt using a 14 mm socket with a /₂ drive, which is inserted in to the vise, as illustrated.

Audi A4 from VIN 8K-9-066500 and Audi A5 from VIN 8T-9-008000: The aluminum bolts -2 through 11- may be used twice. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow-.

Fig 2: Identifying Bolts Marked With An "X" May Not Be Used Again
Courtesy of AUDI OF AMERICA, LLC
Bolts marked with an "X" may not be used again.
Audi A4 through VIN 8K-9-066499: Always replace the aluminum bolts.
Audi A5 through VIN 8T-9-007999: Always replace the aluminum bolts.