Wheel Bearing Unit, Front Wheel Drive (Fwd), Removing And Installing: Installing

Installation is the reverse of removal, With Special Attention To The Following: 

Tightening Specifications. Refer To OVERVIEW - WHEEL BEARING, VEHICLES WITH FRONT WHEEL DRIVE (FWD) .

-- Install the front seal and grease the stub axle -arrow- lightly with Grease.

Fig 1: Front Seal And Grease Stub Axle

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper and the brake rotor. Refer To REAR BRAKES .

-- Drive in the protective cap with the :3241/4  .

Fig 2: Driving In Dust Cap

Courtesy of AUDI OF AMERICA, LLC

-- Install the wheel.

-- Tighten the wheel. Refer To WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Tighten the wheel bearing unit collar bolt, but only when the vehicle is resting on its wheels. Refer To DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .