Front Bonded Rubber Bushing, Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Front Rubber Bonded Bushing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wheel bearing housing. Refer To WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FRONT WHEEL DRIVE (FWD) VEHICLES .

In Order To Remove The Front Rubber Bonded Bushing, The :T40184/2 -3- Must Be Mounted On The Front Rubber Bonded Bushing In Such A Way So That The Lugs -2- Fit Into The Grooves -4-.

-- Place the tools on the front bonded rubber bushing and the wheel bearing housing as illustrated.

Fig 2: Place Tools On Front Bonded Rubber Bushing And Wheel Bearing Housing As Illustrated

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When mounting the wheel bearing housing onto the :T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.

:VW411
:T40184/2
Wheel bearing housing
:T40184/1 . The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the :T40184/1 .

-- Press out the front rubber bonded bushing.