Upper Transverse Link, Removing And Installing: Installing

-- Install the upper control arm -3- on the threaded connection -1- by hand.

Fig 1: Connections -1- & -2- & Upper Transverse Link -3-

Courtesy of AUDI OF AMERICA, LLC

-- Lay a ruler or straight edge -1- flat against the upper control arm -arrows-.

Fig 2: Lay A Ruler Or Straight Edge Flat Against Upper Control Arm

Courtesy of AUDI OF AMERICA, LLC

-- Position the upper control arm -2- so dimension -a- = 8 mm ± 1 mm between the straight edge -1- and the stamping burr on the upper control arm -2-.

-- Tighten the upper control arm -3- on the subframe in this position.

Fig 3: Connections -1- & -2- & Upper Transverse Link -3-

Courtesy of AUDI OF AMERICA, LLC

-- Screw wheel bearing housing on control arm and tighten new nut to 20 Nm.  Note the installation position of the centering washer -2-.

-- Install subframe on vehicles with Front-Wheel Drive (FWD). Refer To REAR AXLE, REMOVING AND INSTALLING, FRONT WHEEL DRIVE (FWD) VEHICLES .

-- Install subframe on vehicles with All-Wheel Drive (AWD). Refer To REAR AXLE, REMOVING AND INSTALLING, ALL WHEEL DRIVE (AWD) VEHICLES .

-- Loosen the threaded connection -1-.

Fig 4: Identifying Threaded Connection

Courtesy of AUDI OF AMERICA, LLC

-- Lift the wheel bearing hub into curb weight position. Refer To WHEEL BEARING IN CURB WEIGHT, REAR AXLE, LIFTING VEHICLES WITH COIL SPRING and tighten the threaded connection -1-.

Tightening Specifications. Refer To OVERVIEW - TRANSVERSE LINK .

-- Tighten the wheel. Refer To WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Perform an axle alignment. Refer To VEHICLE ALIGNMENT .

The Axle Alignment Must Be Performed On A VW/Audi Approved Alignment Stand.