LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 78 (Rear Suspension (1 Of 2) (Coupe)) >> 42 Rear Suspension >> Control Arm, Tie Rod >> Lower Transverse Link, Removing And Installing >> Removing

Lower Transverse Link, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Determine dimension -a- from the center of the wheel to the lower edge of the wheel housing before starting work while the vehicle is resting on its wheels.

Fig 1: Dimension From Center Of Wheel To Lower Edge Of Wheel Housing
GWWA42-10125Courtesy of AUDI OF AMERICA, LLC

-- Place the vehicle on a hoist.

-- Remove the wheel.

-- Remove the coil spring. Refer To SPRING, REMOVING AND INSTALLING .

-- On vehicles with a level control system sensor -1-, remove the bolt -2-.

Fig 2: Identifying Level Control System Sensor And Bolt
GWWA42-10208Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -4-.

Fig 3: Identifying Bolt
GWWA42-10216Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -3-.

Fig 4: Bolt -1- And Spacer Tube -2- And Nut -3-
GWWA42-10209Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the spacer tube -2-.

NOTE:

Axle Alignment Is Necessary If The Nut -3- Is Loosened Or The Bolt -1- Is Removed.

-- Remove the bolt -1-.

Fig 5: Identifying Lower Control Arm And Bolt
GWWA42-10207Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -3- and bolt -2-.

-- Remove lower transverse link.