Condenser, Removing And Installing, RS Models: Notes

The radiator and condenser may have small indentations on the fins even when installed correctly. It is not damage. Do not replace the radiator or condenser because of those small indentations.

Slight deformations on the side securing straps on the condenser (for example, due to an accident), can result in an unparallel flow from the condenser and radiator; this can be resolved by pulling the straps back as long as the function/condenser sealing is not impaired. The straps on the condenser do not need to be replaced if there are small deformations.

A slight bending of the condenser (up to 4 mm) is permissible as long as there is sufficient distance (minimum 4 mm) between the condenser and the radiator and the function/sealing of the condenser (of the refrigerant circuit) is not impaired. The condenser does not have to be replaced if there are slight deformations.

Depending on the vehicle version, there are different condenser versions. Refer to CONDENSER, CHECKING VERSION  and the Parts Information.

The Audi RS 4 and Audi RS 5 have a condenser version that is not installed on other vehicles in this model line. For the correct allocation and refrigerant capacity. Refer to, Parts Information and APPROVED REFRIGERANT OILS AND REFRIGERANT OIL CAPACITIES

It may be necessary to evacuate the refrigerant circuit and remove the refrigerant pipes from the condenser in order to remove the condenser from the front end or to remove the radiator depending on the version of the radiator and the condenser (for example, on the Audi RS 4 and the Audi RS 5). Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .