Condenser, Removing And Installing, RS Models: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is done is reverse order, observe the following:

NOTE:

The removed condenser contains refrigerant oil that must be returned to the refrigerant circuit (with the new condenser). Refer to REFRIGERANT CIRCUIT COMPONENTS, REPLACING

-- Install the refrigerant lines on the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .

-- Evacuate the refrigerant circuit and fill it. Refer to REFRIGERANT CIRCUIT

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

-- Install the remaining removed components.

-- Turn on the ignition.

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.