Overview - Rear Window

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Lid Window Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Rear Window
- Distance -a- to roof = 2.5 mm.
- Center the distance -d- to the >>D-pillar<< = 3 mm.
- Before removing, disconnect all electrical connectors and secure the terminals to the middle of the window on the inside using adhesive tape.
Adhesive Bead
- Bead width = 8 mm ^{± 2 mm}
- Bead height = 12 mm ^{+ 2 mm}
- Distances to the window edge:
  - Dimension b = 15 mm
  - Dimension c = 24 mm
  - Dimension e = 16 mm
Spacer
- Make 3 markings each on the top and bottom edges of the window.
Adhesive Stop Profile
- Distance to the edge of the window dimension f = 24 mm
- Bond the adhesive stop profile directly by the window defroster distributing wire.
- Window adhesive must not come into contact with the rear window defroster distributing wire.