Speech Input Control Module -J507-, Removing And Installing, Through 10/27/2008: Installing

WARNING: This page is about a different variant/trim than selected.

-- Install In Reverse Order Of Removal.

-- Make Sure That Harness Connector Between Speech Input Control Module -J507- And Radio -R- Engages Correctly In Radio -R-.

Perform The Following Function Test:

-- Switch on the Radio -R-.

-- Briefly depress PTT button on Multifunction steering wheel.

A "Ping" Tone Sounds, The Speech Input System Is Active.

-- Say the command "Help".

Since the Radio -R- is active, the speech dialog system responds with "Commands for the radio are...".

Depending On The Equipment, Other Functions Can Be Selected:

-- If a telephone is installed, say "telephone".

The Speech Dialog System Switches To The Telephone Mode.

-- Press and hold the PPT button for approximately one second.

The Speech Dialog System Responds With "Cancel" And Is Deactivated.