Installed Calibration Tool : Vas6350 Overview

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Calibration Tool VAS6350

Courtesy of AUDI OF AMERICA, LLC

Calibration Tool - Wheel Center Mountings:VAS6350/1
Calibration Tool - Wheel Center Mountings:VAS6350/1
Right angle bracket
- Calibration Tool - Spacing Laser:VAS6350/2 mount
Plastic Foot
- Three on the Calibration Tool - Lane Change Calibration Tool:VAS6350/4 underbody
- Can be adjusted for adjusting the horizontal position of the Calibration Tool - Lane Change Calibration Tool:VAS6350/4
Calibration Tool - Linear Laser:VAS6350/3
- On the Calibration Tool - Lane Change Calibration Tool:VAS6350/4
- Switching on and off, refer to Operating Instructions.
Calibration Tool - Spacing Laser:VAS6350/2
- Notes on operation, refer to Operating Instructions.
Level on calibration platform
- On the Calibration Tool - Lane Change Calibration Tool:VAS6350/4
- for checking the horizontal position
Left angle bracket
- Calibration Tool - Spacing Laser:VAS6350/2 mount
Calibration Tool - Lane Change Calibration Tool:VAS6350/4
- Between the angled brackets on the Calibration Tool - Lane Change Calibration Tool:VAS6350/4 and the Calibration Tool - Wheel Center Mountings:VAS6350/1 -dimension A- 1.47 m to 1.90 m

Calibration Tool - Lane Change Calibration Tool:VAS6350/4 Orientation

-- Position the Calibration Tool - Lane Change Calibration Tool:VAS6350/4 behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the illustration, refer to INSTALLED CALIBRATION TOOL : VAS6350 OVERVIEW

-- Bring the Calibration Tool:VAS6350/4 into a horizontal position.

-- To do so, twist plastic feet under Calibration Tool - Lane Change Calibration Tool:VAS6350/4 so that air bubble in level is located exactly in the center of the indicator -arrow-.

Fig 2: Identifying Bubble Level (Sight Glass) On Calibration Tool VAS 6350

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Make Sure Light Does Not Reflect Off The Calibration Tool - Lane Change Calibration Tool:VAS6350/4 .

Reflections affect the Rearview Camera -R189- and may make it impossible to perform the calibration.

-- Switch on the Calibration Tool - Linear Laser:VAS6350/3 -1- on the Calibration Tool - Lane Change Calibration Tool:VAS6350/4 and align the entire Calibration Tool:VAS6350/4 , so that the laser beam points to the middle of the vehicle height above the Audi rings.

Fig 3: Switching On Line Laser VAS 6350/3

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the Audi rings are centered on the rear. Adjust the laser beam as needed.

Continue calibrating the Rearview Camera -R189-, refer to Rearview Camera -R189-, CALIBRATING .