Chip Card Reader Control Module -J676- Connector Assignments, Japan, From11/03/2008
WARNING: This page is about a different variant/trim than selected.
Chip Card Reader Control Module -J676-
NOTE:
Unlisted Connector Terminals Are Not Assigned.
Multi-Pin Connector, 32-Pin
1-16 - to the Traffic Data Antenna -R173-
17 - VICS data wire to the Information Electronics Control Module 1 -J794-
19 - VICS data wire to the Information Electronics Control Module 1 -J794-
21 - Switch-on signal to the Information Electronics Control Module 1 -J794-
22 - Terminal 30
23 - ETC data to the Information Electronics Control Module 1 -J794-
25 - ETC data from the Information Electronics Control Module 1 -J794-
28 - Terminal 31