Corrugated Hose Washer Fluid Line, Repairing: Notes

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Hot Air Blower:VAS5179 or
Wiring Harness Repair Set - Hot Air Blower:VAS1978/14A from the Wiring Harness Repair Set:VAS1978B
Hose Cutting Pliers:VAS6228

NOTE:

Corrugated hoses can be replaced with heat-shrink sleeves. Refer to the Parts Information.

NOTE:

Area to be repaired must not be under stress of stretching or bending.

If the damaged area is longer than 20 mm, a new section of corrugated hose must be inserted and the procedure described in the following must be performed twice.