Valve Adapter

WARNING: This page is about a different variant/trim than selected.

Courtesy of AUDI OF AMERICA, LLC

A - 5/8"-18 UNF thread for conical seal

B - Internal thread with valve opener

M10 x 1.25 VAG1785/9 (for connections with valve on high-pressure side)
M10 x 1.5 VAG1785/10 (for connections with valve on high-pressure side)

NOTE:

A Schrader valve is screwed into connection -A-.

A valve opener must be installed in the charging hose connection.

Various adapters from adapter set are also part of the Refrigerant Circuits Adapter Set 1:VAS6338/1 .

A/C Adapter Set:VAG1786

Courtesy of AUDI OF AMERICA, LLC

A - A/C Adapter Set - Adapter 1:VAG1786/1 (only for connections with small valve insert on low-pressure side)

B - Charging hose with union nut 5/8"-18 UNF (short version)

C - A/C Adapter Set - Adapter 2:VAG1786/2 .

NOTE:

For connections with large valve insert (standard on "Zexel/Valeo" compressors, gradual change to small valve insert from 10/1994), use is to be made of adapter VAG1785/10 (remove valve from adapter VAG1785/10 or install valve opener in charging hose -B-).

Beginning from production year 2006, the name of the "Zexel" A/C compressor was changed from "Zexel" to "Valeo".

Refrigerant Sockets:T10364

Courtesy of AUDI OF AMERICA, LLC

NOTE:

For removing and installing service connections and valve units when the refrigerant circuit is empty.