Wheel Bearing Unit, Servicing: Procedure

WARNING: This page is about a different variant/trim than selected.

Wheel bearing unit is removed. Refer To WHEEL BEARING UNIT, REMOVING AND INSTALLING .

Wheel Hub, Removing From Wheel Bearing

Fig 1: Identifying Tool Set Up

Courtesy of AUDI OF AMERICA, LLC

-- Arrange The Special Tools As Shown.

:VW412
:T10230/3
:T10230/8
Wheel Bearing Unit
:VW402
:VW401

-- Press The Wheel Hub Out Of The Wheel Bearing.

Bearing Inner Race, Removing From Wheel Hub

Fig 2: Bearing Inner Race Remover Tools

Courtesy of AUDI OF AMERICA, LLC

-- Prepare the puller from the :VAS701003 as follows:

-- Install the :VAS701003/1 on the :VAS701003/7 .

-- Install the :VAS701003/2 in the adapter sleeve and attach the :VAS701003/3 .

Bearing Inner Race Version 1:

Fig 3: Place Puller On Ball-Cage

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ball-cage assembly from the bearing inner race -2-.

-- Place the puller -1- as shown on the ball bearing race -arrow- of the bearing inner race.

Bearing Inner Race Version 2:

Fig 4: Place Puller On Ball-Cage

Courtesy of AUDI OF AMERICA, LLC

-- Place the puller -1- on the groove -arrow- of the bearing inner race -2-.

Continuation For All Versions:

Fig 5: Clamp The Puller On The Bearing Inner Race -2-

Courtesy of AUDI OF AMERICA, LLC

-- Clamp the puller on the bearing inner race -2- by turning the :VAS701003/7 with the :VAS701003/5 in the direction of the -arrow- and counterhold the :VAS701003/1 with the :VAS701003/4 .

-- Remove the bearing inner race with the :VAS701003/2 from the wheel hub -1-.

Wheel Hub, Pressing In Wheel Bearing

Fig 6: Always Set Wheel Bearing Down On Wheel Hub -2- (Wheel Bearing -1- Facing Up)

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Avoid Contaminating With Dirt And Damaging The Seal When Setting Down/Storing.

The Wheel Bearing -1- Must Face Up In Order To Remove The Wheel Bearing Unit.
Always Set The Wheel Bearing Unit Down On The Wheel Hub -2-.

Never Reach Inside When Lifting The Wheel Bearing.

Fig 7: Correct & Incorrect Holding Of Wheel Bearing
Courtesy of AUDI OF AMERICA, LLC
Hold The Wheel Bearing Only On The Outside.

-- Arrange The Special Tools As Shown.

Fig 8: Identifying Punch VW 412, Thrust Plate VW 402, Wheel Hub, Ball Bearing & Thrust Plate VW 401

Courtesy of AUDI OF AMERICA, LLC

:VW412
:VW402
Wheel Hub
Wheel Bearing
:VW401

The Reworked Surface Of The Wheel Bearing Outer Race Faces Down.

CAUTION:

There Is A Risk Of Damaging Or Contaminating The Wheel Bearing.

When Setting Down Or Pressing In, Make Sure There Is No Dirt Or Contaminants Between The :Vw401 And The Wheel Bearing.

-- Press The Wheel Hub Into The Wheel Bearing.

-- Install The Wheel Bearing Unit. Refer To WHEEL BEARING UNIT, REMOVING AND INSTALLING .