Guide Link Bonded Rubber Bushing, Removing And Installing, Hydraulic Bonded Rubber Bushing 75 Mm Diameter

Special Tools And Workshop Equipment Required 

• Press Plate:VW402 
• Press Piece - Multiple Use:VW412 
• Press Piece - Split Tube:VW463/2 
• Bearing Installer - Wheel Bearing:3144 
• Workshop Press:VAG1290A 
• Installation Lubricant -- (1:20 thinned with water).

• The guide link is removed. Refer To GUIDE LINK, REMOVING AND INSTALLING .

Remove The Hydraulic Bonded Rubber Bushing 

• The guide link is removed. Refer To GUIDE LINK, REMOVING AND INSTALLING 

-- Mark The Installed Position -Arrow- On The Hydraulic Bonded Rubber Bushing -4-.

Use A Waterproof Marker.

-- Order The Special Tools As Illustrated.

1. :VAG1290A  punch
2. :VW412 
3. :VW463/2 
4. hydraulic bonded rubber bushing
5. Guide link
6. :3144 
7. :VW402 

-- Remove the hydraulic bonded rubber bushing -4- from the guide link -5-.

Installing The Hydraulic Bonded Rubber Bushing 

-- Transfer the marking from the old hydraulic bonded rubber bushing to the new one.

-- Lightly coat the new hydraulic bonded rubber bushing with Installation Lubricant --.

Installation Position, Hydraulic Bonded Rubber Bushing 

The notch -1- is on the steering axle and faces the inside of the guide link.

The arrow -2- faces the inside of the guide link.

-- Install the hydraulic bonded rubber bushing -4- in the guide link -5- paying close attention to the installed position.

-- Order the special tools as illustrated.

1. :VAG1290A  punch
2. :VW412 
3. :VW463/2 
4. Hydraulic bonded rubber bushing
5. Guide link
6. :3144 
7. :VW402 

-- Install the hydraulic bonded rubber bushing -4- into the guide link -5-.

-- Pay close attention to the marking -arrow-.

-- Check the press-in depth -a- of the hydraulic bonded rubber bushing inside the guide link.

Dimension -a- = 18 mm.

-- If dimension -a- is not reached, then press the hydraulic bonded rubber bushing again.

-- Install the guide link. Refer To GUIDE LINK, REMOVING AND INSTALLING .