Drive Axle, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation Is The Reverse Of Removal, With Special Attention To The Following:
-- Insert Both Of Upper Control Arm Joint Pins -2- In The Wheel Bearing Housing And Insert The Bolt -1-.
NOTE:
Push The Upper Control Arms Down As Far As Possible While Tightening The Bolts!
-- Tighten The Threaded Connection -1-.
Tightening Specifications. Refer To OVERVIEW - WHEEL BEARING .
Tightening Specifications. Refer To OVERVIEW - SUBFRAME .
-- Tightening Specification for drive axle to flange shaft/transmission. Refer To OVERVIEW - WHEEL BEARING .
-- Install The Wheel.
-- Tighten the wheel. Refer To WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Tighten the drive axle to wheel hub threaded connection. Refer To DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .