Clamp On Triple Roller Joint And Outer Joint, TENSIONING

Special Tools And Workshop Equipment Required 

• Pliers:3340 
• Hose Clip Pliers:VAG1275A 
• Clamping Pliers:VAG1682A 

Depending On The Version Of The Clamp, Use The Following Tools:

Install And Tension The Galvanized Clamps Using :VAG1275A  as Illustrated.

Fig 1: Tensioning Clamp Using Hose Clamp Pliers V.A.G 1275

Courtesy of AUDI OF AMERICA, LLC

-- Make Sure The Edges Of The Clamping Pliers Are Seated In The Corners Of The Hose Clamp When Doing So.

Mount And Tension Stainless Steel Clamps Using :VAG1682A  as Illustrated.

Fig 2: Identifying Clamping Pliers VAG 1682A

Courtesy of AUDI OF AMERICA, LLC

-- Make Sure That The Jaws Of The Tension Clamp Seat In The Corners -Arrows B- Of The Connecting Tube.

-- Tighten The Clamp By Turning The Spindle Using A Torque Wrench -C- (Do Not Tilt The Pliers).

• The Hard Material Of The CV Boot (Compared To Rubber) Makes It Necessary To Use A Stainless Steel Hose Clamp. It Is Only Possible To Tighten The Hose Clamp With :VAG1682A  .
• Tightening Specification: 20 Nm. 
• Use torque wrench with 5 to 50 Nm  range (for example, :VAG1331  ).
• Make sure the spindle threads on the pliers -A- Move Freely. Grease With MoS₂ grease if necessary.
• If The Thread Is Tight, For Example, Dirty, The Required Tensioning Force For The Hose Clamp Will Not Be Achieved In Spite Of Correct Torque Specification Settings.

Mount and Tension the Clamp with the Retaining Tabs Using :3340  as Illustrated.

Fig 3: Close Clamp Using Pliers 3340

Courtesy of AUDI OF AMERICA, LLC

-- Engage The Clamp At The First Catch By Hand.

-- Close The Clamp Using :3340  .