Wheel Bearing Unit: Installing

Install In Reverse Order Of Removal. Note The Following: 

Tightening specifications, Refer To WHEEL BEARING HOUSING, WHEEL BEARING UNIT AND COIL SPRING SHOCK ABSORBER OVERVIEW, FWD .

-- Install the front seal and grease the stub axle -arrow- lightly with grease.

Fig 1: Front Seal And Grease Stub Axle

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper and disc. Refer To REAR BRAKE CALIPER, REMOVING AND INSTALLING .

-- Install the protective cap using the :3241/4  .

Fig 2: Driving In Dust Cap

Courtesy of AUDI OF AMERICA, LLC

-- Install wheel.

-- Tighten wheel. Refer WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Tighten the wheel bearing unit collar bolt, but only when the vehicle is resting on its wheels. Refer To THREADED CONNECTION BETWEEN DRIVE AXLE AND WHEEL HUB, LOOSENING AND TIGHTENING .