Wheel Bearing Housing Rubber Bonded Bushing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove wheel bearing housing. Refer To WHEEL BEARING HOUSING .

In order to remove the front rubber bonded bushing, the pressure plate:T40184/2 -3- must be mounted on the front rubber bonded bushing in such a way so that the lugs -2- fit into the grooves -4-.

Fig 1: Front Rubber Bonded Bushing

Courtesy of AUDI OF AMERICA, LLC

-- Place the tools on the front bonded rubber bushing and the wheel bearing housing as illustrated.

Fig 2: Place Tools On Front Bonded Rubber Bushing And Wheel Bearing Housing As Illustrated

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When mounting the wheel bearing housing onto the sleeve:T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.

:VW 411
:T40184/2
Wheel bearing housing
:T40184/1 . The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the :T40184/1 .

-- Press out the front rubber bonded bushing.