Coupling Rod With Stabilizer Bar: Installing

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal. Note The Following:

NOTE:

Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension screws when vehicle is in curb weight or control position.

Wheel bearing, lifting to curb weight position on vehicles with coil springs, Refer To WHEEL BEARING WITH COIL SPRING, LIFTING TO CURB WEIGHT POSITION

-- Insert the stabilizer bar and install the right bolts loosely.

-- First install the left and right bolts -2- loosely.

Fig 1: First Install Left And Right Bolts Loosely

Courtesy of AUDI OF AMERICA, LLC

-- Then tighten the left and right bolts -2- evenly.

-- Insert the bolt -1- with the washer -2- and tighten the left and right nuts -3-.

Fig 2: Identifying Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the left and right bolts -4-.

-- An axle alignment may be required. Refer To WHEEL ALIGNMENT .