Wheel Bearing Unit, AWD

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required

Wheel Hub, Removing from Wheel Bearing

Fig 1: Identifying Tool Set Up

Courtesy of AUDI OF AMERICA, LLC

-- Install special tools as shown in illustration.

-- Press the wheel hub out of the wheel bearing.

Remove the bearing inner race from the hub.

Fig 2: Bearing Inner Race And Spinning Washer

Courtesy of AUDI OF AMERICA, LLC

-- Insert the separating tool between the bearing inner race -1- and the wheel hub -2- and pretension with the spindle.

NOTE:

Use a commercially available separating tool such as the :Kukko 15/3 with 17/3 .

-- Install special tools as shown in illustration.

Fig 3: Identifying Tool Set Up

Courtesy of AUDI OF AMERICA, LLC

-- Press The Bearing Inner Race From The Hub.

Pressing Wheel Hub Into Wheel Bearing

CAUTION:

The wheel bearing -1- must always face up.

Fig 4: Always Set Wheel Bearing Down On Wheel Hub -2- (Wheel Bearing -1- Faceing Up)

Courtesy of AUDI OF AMERICA, LLC

-- Always Set The Wheel Bearing Unit Down On The Wheel Hub -2-.

-- Install Special Tools As Shown In Illustration.

Fig 5: Identifying Punch VW 412, Thrust Plate VW 402, Wheel Hub, Ball Bearing & Thrust Plate VW 401

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Reworked Surface On The Wheel Bearing Outer Race Faces Down.

CAUTION:

When Installing Or Pressing In, Make Sure There Is No Dirt Or Contaminants Between The :VW 401 -5- And The Ball Bearing -4-.

-- Press The Wheel Hub Into The Wheel Bearing.

-- Install Wheel Bearing Unit. Refer To WHEEL BEARING UNIT .