Inner CV Joint, 100 Mm Diameter Or 108 Mm Diameter: Notes

Special Tools And Workshop Equipment Required 

• Thrust plate:VW 401 
• Thrust plate:VW 402 
• Punch:VW 409 
• Punch:VW 412 
• Support sleeve:VW 522 
• Clamp:40 - 204 A 
• Assembly Tool:T10065  Can Also Be Used Instead Of Clamp:40-204 A  .
• Torque Wrench:V.A.G 1331 
• CV Joint Boot Clamp Tool:V.A.G 1682 
• Circlip Pliers (Commercially-Available)

Fig 1: Driving Cover Down With Copper Or Brass Drift

Courtesy of AUDI OF AMERICA, LLC

-- Secure The Drive Axle With Protective Covers In A Vise Clamp.

-- Drive Cover Down With Copper Or Brass Drift.

-- Drive Cover Down With Copper Or Brass Drift.

Fig 2: Secure Drive Axle With Protective Covers In A Vise Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Only Open And Remove The "Small" Protective Boot Clamp.

-- Remove Circlip.

Fig 3: Opening Clamps And Pulling Off CV Joint Boot From Inner Joint

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Inner CV Joint From The Drive Axle Using The Special Tools Illustrated.

Fig 4: Pressing CV Joint Off Of Drive Axle

Courtesy of AUDI OF AMERICA, LLC

-- Remove The CV Joint Boot From The Drive Axle.