Central Valve: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
The central valves are attached to the impact member under the bumper cover in the rear and on the left side.
-- Remove rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
WARNING:
Always Wear Safety Goggles!
NOTE:
The DRC lines must be extracted before disconnecting them from the central valve. Refer to DYNAMIC RIDE CONTROL (DRC), DRAINING AND FILLING .
Perform this step on both wiring harnesses on the central valve.
-- Remove the union nuts -7- and -8- or -11- and -12-, depending on the central valve.
-- Remove the screws -13- and the central valve.