General Repair Information: Notes
WARNING: This page is about a different variant/trim than selected.
General Information
To perform a problem-free and successful repair, extreme caution and cleanliness, as well as properly functioning tools are an important requirement. Understandably, general safety guidelines apply when performing repairs.
A series of applicable general notes for individual repair procedures - otherwise listed several times at many points in the Service Information - has been collected here. They apply for this Service Information.
- Thoroughly clean connecting points and their surrounding areas before loosening.
- Place removed parts on a clean surface and cover to prevent contamination. Use foils and paper. Only use lint-free cloths!
- Only install clean components: Only unpack replacement parts immediately prior to installation.
- Use exclusively lubricants and sealants marked with part numbers.
- Carefully cover or seal open components, if repairs are not carried out immediately.
WARNING:
If Vehicle Will Be Driving On The Streets, All Screws And Nuts Must Be Tightened Properly!
WARNING:
Danger Of Personal Injury Caused By The Engine Starting Automatically On Vehicles With The Start/Stop System.
- When the Start/Stop System is on (recognizable by a message in the instrument cluster), the engine may start automatically.
- Make sure the Start/Stop System is off whenever working on the vehicle. Turn off the ignition and turn it back on only when necessary.