End Plate, Removing And Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of End plate With Components

GWWA50-10221

Courtesy of AUDI

Fender
End Plate
-- Remove front wheel.

-- Remove the rear part from the wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER, EXCEPT AUDI RS5 .
- Loosen the windshield washer fluid reservoir on the left side.
  -- Remove the bolts -3-, unclip from the fender rear bracket -item ) FENDER, REMOVING AND INSTALLING - REAR BRACKET and slide the end plate down and out.
Bolts
- 1.5 Nm
Clip
- Quantity: 2