LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (Wiper/Washer Systems (Coupe)) >> 92 Wiper/Washer Systems >> Windshield Washer System >> Windshield Washer Pump, Removing And Installing >> Removing

Windshield Washer Pump, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Disconnecting Electrical Connector
GWWA92-10090Courtesy of AUDI OF AMERICA, LLC

-- Turn Off The Ignition And Remove The Key.

-- Remove The Left Front Wheel.

-- Remove The Left Front Wheel Housing Liner. Refer To FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING, AUDI RS5 .

-- Disconnect The Connector -4-.

-- Place A Drip Tray Under The Windshield Washer Fluid Reservoir.

-- Release The Clip -2- In The Direction Of The -Arrow- And Remove The Washer Fluid Line -1- From The Windshield Washer System Washer Fluid Pump.

-- Remove The Windshield Washer Pump -V5- -Item 3- Upward Out Of The Washer Fluid Reservoir.

NOTE:

Replace The Windshield Washer Pump -V5- Bracket -1- If It Is Damaged.

Fig 2: Pressing Damaged Bracket -1- Out Of Mount In Washer Fluid Reservoir -2- Toward Outside Of Vehicle -Arrow-
GWWA92-10103Courtesy of AUDI OF AMERICA, LLC

Push The Damaged Bracket Out Of The Mount In The Windshield Washer Fluid Reservoir -2- -Arrow-.