Headlamp Washer Pump -V11-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Disconnecting Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Washer Fluid Reservoir (Refer To WASHER FLUID RESERVOIR, REMOVING AND INSTALLING ), But Only Pull It Out Until The Headlamp Washer Pump -V11- Is Accessible.

-- Place A Drip Tray Under The Windshield Washer Fluid Reservoir.

-- Disconnect The Connector -1-.

-- Remove The Washer Fluid Hose -3- From The Headlamp Washer Pump -V11-.

NOTE:

There May Be A Clip Installed Rather Than A Hose Clamp.

-- Remove The Headlamp Washer Pump -V11- -Item 2- Upward Out Of The Washer Fluid Reservoir.