Impact Member, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Disconnect the connector on the Radio Frequency Controlled Clock Receiver -J489- .

NOTE:

If the impact member -3- is replaced, the Radio Frequency Controlled Clock Receiver -J489- must be removed. Refer to Clock .

Fig 1: Counterholding Nuts To Remove Bolts

-- Remove the bolts -1- by counterholding the nuts -2- .

-- Remove the impact member -3- .