Bumper Cover, Removing And Installing, AUDI RS5: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Disconnecting Electrical Connector

-- Remove the tail lamps. Refer to Tail Lamps .

-- If equipped, disconnect the electrical connector -1- on the Parking Aid Control Module -J446- .

-- Free up the electrical wiring harness on the control module bracket -arrow- by disconnect the cable tie -2- .

-- Press the grommet -3- outward.

-- Remove the nut -2- .

Fig 2: Identifying Bolts On Lower Bumper Cover Section

-- Remove the bolts -1- on the lower bumper cover section.

-- Loosen the adjusting bolt by turning it to the left to then release the bumper cover retainer -3- .

Fig 3: Releasing Catch For Bumper Cover By Removing Bolts

-- Remove the left and right bolts -1- for the bumper cover side piece.

-- Remove the left and right bumper cover side pieces on the side panel -arrow- .

-- Remove the bumper cover -2- . The parking aid sensor electrical wire must be guided out through the body opening.

-- Free up the electrical wiring harness spiral clip.

NOTE:

Use a soapy solution if necessary make removal easier.