LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 57 (Bumpers (Coupe)) >> 63 Bumpers >> Front Bumper >> Impact Member, Removing And Installing >> Impact Member, Removing And Installing, Vehicles Through My 2011 >> Removing

Impact Member, Removing And Installing, Vehicles Through My 2011: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Cable Tie -1-, Bumper Cover Spacer -2-, Electrical Wiring Harness -3-, Electrical Connector -4- & Impact Bar -5-
GWWA63-10213
NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front bumper cover. Audi A5. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 , Audi RS 5. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .

-- Audi RS 5: Remove the air duct. Refer to [For engine(s) CAED,CAEB,CPMB,CPMA] Charge Air System[For engine(s) CAED,CAEB,CPMB,CPMA] Charge Air System .

-- Disconnect the electrical connector -4- on the horns and free up the electrical wiring harness -3- on the horn bracket.

-- Free up the washer nozzle water drain hose by disconnecting the cable tie -1- .

-- Remove the bolts -arrows- and the bumper cover spacer -2- .

-- Remove the impact bar -5- from the mounts.

NOTE:

Pry the impact bar out of the mounts if it is not easy to remove.

scientia non olet · About LEMON Manuals