Impact Member, Removing And Installing, Vehicles From My 2012: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
When installing, bring all cable ties back to same positions.
-- Remove the front bumper cover. Audi A5. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 , Audi RS 5. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .
-- Audi RS 5: Remove the air ducts. Refer to [For engine(s) CAED,CAEB,CPMB,CPMA] Charge Air System[For engine(s) CAED,CAEB,CPMB,CPMA] Charge Air System .
-- Disconnect the connector -4- from the horns.
-- Pull the release button -5- and am free up the impact member to remove the windshield washer fluid hose -6- .
-- Remove the nuts -7- and bolts -2- upward.
-- Remove the impact bar -1- from the mounts -3- .
NOTE:
Pry the impact bar out of the mounts if it is not easy to remove.