Bumper Cover, Removing And Installing, Except AUDI RS5: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
-- If necessary, disconnect the electrical connector to the Outside Air Temperature Sensor -G17- and the electrical connectors to the front parking aid sensors. Refer to Parking Aid .
-- Remove the bolt -3- .
-- Remove the bolt -2- and the quick-release coupling -1- on the front bumper noise insulation.
-- Remove the wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER, EXCEPT AUDI RS5 .
-- Disconnect the electrical connector -1- on the fog lamp.
-- Remove the bolts -arrows- .
-- Disengage the side walls on the front side panel and remove the bumper cover forward.