Overview - Rear Lid Latch

WARNING: This page is about a different variant/trim than selected.

Fig 1: Hood Lock, Removing And Installing

Courtesy of AUDI OF AMERICA, LLC

Lid Latch
- Loosen the upper bumper cover and push it aside.
- Disconnect the lid lock cable at the coupling.
- Disconnect the connector.
- Remove the bolts -1 and 2-.
  NOTE:
  To Adjust The Hood Height, Move The Lid Lock Up Or Down As Required.
Lock Carrier
Bolt
- 11 Nm
Clip
- Slide the clamp with the electrical wire onto the tab on the lock carrier.
Lid Lock Wire
Tab