Overview - Door

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Front Door Assembly

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 32 Nm
Bolt
- 8 Nm
Cap
- For the door arrester
Door Arrester
- Removing and installing. Refer to DOOR ARRESTER, REMOVING AND INSTALLING .
Bolt
- 25 Nm
Cap
- Install on the threaded pin.
Threaded Pin
- 30 Nm
Upper Door Hinge
Bolt
- 32 Nm
Bolt
- 45 Nm
  NOTE:
  The bolt is a fitting bolt so it is generally not necessary to adjust the door using it.
  
  If it is necessary to make an adjustment using these bolts, the bolt can be replaced with one of the same length and strength category.
Bolt
- 8 Nm
Seal
- For the door arrester
Bolt
- 32 Nm
Bolt
- 45 Nm
  NOTE:
  The bolt is a fitting bolt so it is generally not necessary to adjust the door using it.
  
  If it is necessary to make an adjustment using these bolts, the bolt can be replaced with one of the same length and strength category.
Bolt
- 32 Nm
Lower Door Hinge
Threaded Pin
- 25 Nm
Cap
- Install on the threaded pin.